Growing Environment

Can-Filters® has designed and built the Can-Lite™ for convenience and long life. 100% Australian granulated carbon, aluminum top and bottom, integrated flange and 51% open perforation are features of the Can-Lite filter. The Can-Lite is available in 7 sizes with a CFM range of 89 to 3000. Can-Lite is manufactured in a dedicated carbon filter plant in North America. Each filter is shrink wrapped, boxed and labeled for ease of use.

Can-Filters® has designed and built the Can-Lite™ for convenience and long life. 100% Australian granulated carbon, aluminum top and bottom, integrated flange and 51% open perforation are features of the Can-Lite filter. The Can-Lite is available in 7 sizes with a CFM range of 89 to 3000. Can-Lite is manufactured in a dedicated carbon filter plant in North America. Each filter is shrink wrapped, boxed and labeled for ease of use.

Ideal-Air™ Pro Series 60 Pint Dehumidifier has automatic restart if power is lost. Easy-to-use digital display humidity readings, internal condensate pump, removable washable filter, 1 speed fan motor, powder-coated metal casing for long life and a heavy-duty compressor. Built-in defrost that is designed for operation down to 41°F. Set upright on their feet for 3 hrs prior to use. 60 pint unit: Temp. Range: 41°F–95°F, condensation removal: (24 hrs) 60 pints (86°F, 80% RH); Power: 4.6 Amps/520 W; Supply Voltage: 115 V - 1 Phase - 60 Hz; R410A. Ideal-Air™ recommends that dehumidifiers use surge protectors and a dedicated electrical circuit. In the event of a power failure, a spike in voltage may occur when the power is reinstated. This can damage the circuit board, which is not covered under warranty.

The Eos® 2 Digital Humidity Controller makes dialing in your room's environment a breeze. It can be used to activate a device to increase humidity in your room or decrease the humidity in your room. The Eos® 2 utilizes a high-quality humidity sensor as well as a photocell for day and night control. Settings are easily programmed with the knob that doubles as a button to change settings. A slide switch controls whether the controller is running in Day, Night or 24 hr mode. 10 Amps/ 120 V/ 60 Hz.

Very low air resistance, easily changed. MERV-5 mesh blocks pollen, dust and other particulate from entering filter. Available in sizes for all filters. A clean Can-Filter® Pre-Filter is an excellent way of extending the working life of your Can-Filter filter.

Can-Filters® has designed and built the Can-Lite™ for convenience and long life. 100% Australian granulated carbon, aluminum top and bottom, integrated flange and 51% open perforation are features of the Can-Lite filter. The Can-Lite is available in 7 sizes with a CFM range of 89 to 3000. Can-Lite is manufactured in a dedicated carbon filter plant in North America. Each filter is shrink wrapped, boxed and labeled for ease of use.

Can-Filters® has designed and built the Can-Lite™ for convenience and long life. 100% Australian granulated carbon, aluminum top and bottom, integrated flange and 51% open perforation are features of the Can-Lite filter. The Can-Lite is available in 7 sizes with a CFM range of 89 to 3000. Can-Lite is manufactured in a dedicated carbon filter plant in North America. Each filter is shrink wrapped, boxed and labeled for ease of use.

Can-Filters® has designed and built the Can-Lite™ for convenience and long life. 100% Australian granulated carbon, aluminum top and bottom, integrated flange and 51% open perforation are features of the Can-Lite filter. The Can-Lite is available in 7 sizes with a CFM range of 89 to 3000. Can-Lite is manufactured in a dedicated carbon filter plant in North America. Each filter is shrink wrapped, boxed and labeled for ease of use.

Quick maintenance with easy filter access that is removable and washable. Low temperature defrosting. Easy to move with built-in handles and wheels. Easy-to-use LED display panel. Removable water tank with an automatic shutoff when reservoir is full. The reservoir for the dehumidifiers is 6 liters or 12.5 pints. 22 pint is 4.0 Amps/420 W. 30 pint is 4.7 Amps/520 W. 50 Pint is 6.9 Amps/720 W. 115 V. Can be plumbed for permanent drainage.

This controller will allow you to precisely monitor and control the environment in your grow room. Featuring an easy-to-use analog interface this digital controller is easy to program and use. Each set point (temperature humidity and CO2) are programmed using a set of dedicated knobs. Readings are displayed on easy-to-read digital displays. The sensor that measures the temperature humidity light and CO2 levels in your room attaches to the controller with a 15 ft cord. Enclosure resists dust

The Eos® Complete Digital Humidity Controller allows you to accurately and efficiently control the humidity levels in your garden. Set your desired humidity level and the controller will activate and deactivate humidifying and dehumidifying equipment appropriately. This controller also features low temperature protection in the event that achieving the desired humidity level results in an undesirable temperature. This Eos® unit features a 15 ft remote sensor that monitors your temperature and humidity levels. The easy-to-use analog style interface makes programming the controller a simple task. Day and night settings allow for accurate environmental control.

Controller turns off your lights if high temperature exceeds set point. Built-in 1 to 30 min hot start delay with HOLD feature. 6 foot temperature probe is accurate to within 2°F. Protects your garden and your plants. Enclosure resists dust, rust and moisture. 15 Amps maximum/ 120 V/ 60 Hz.

This CO₂ Rain® System includes 25 ft of laser-drilled 1/8 in tubing, 6 eye hooks, 1/8 in plastic T fitting and instructions. Additional 100 ft roll of tubing is also available.

This CO₂ Rain® System includes 25 ft of laser-drilled 1/8 in tubing, 6 eye hooks, 1/8 in plastic T fitting and instructions. Additional 100 ft roll of tubing is also available.

• Classic series oscillating wall mount fan.
• Designed for efficient air circulation in compact spaces.
• Ideal for growrooms, greenhouses, homes, garages, workshops, and more.
• Three turn-switch or pull-cord controlled speed settings.
• 90 degree lockable oscillation.
• Durable steel neck support.
• 5 foot (1.5 meter) power cord.
• cETL listed.
• 16 inch (40 centimeter) fan.

• For use with Ona Mist aerosol cans.
• Controls difficult or repetitive odors in small spaces.
• Has an electronic eye that senses bright light or low light.
• Three settings for low light, day light, or 24-hour operation.
• Adjustable time intervals: 7.5 minutes, 15 minutes, or 30 minutes.

Dial A Speed Controller allows you the ability to vary the speed of your inline duct fan. You can “dial in” the appropriate setting for your ventilation needs. Ideal for use with C.A.P. ValuLine centrifugal fans and most other brands. Plug and Play and rated for 230 volt or 120 volt, with fuse protection.

• High performance inline fans.
• Feature superior plastic or metal construction.
• Speed controllable.
• Vibration-free operation.
• Come with pre-installed cords from the manufacturer.
• Protected by a 1 year warranty.
• 12 in (30 cm) 1,060 CFM metal fan.

• Designed to allow airflow in one direction.
• Minimum air leakage: exterior foam gaskets assure a tight seal.
• Aluminum spring-loaded backdraft damper blades.
• 20 gauge steel housing.
• Simple installation: entire assembly inserts into duct.
• Can be installed in any position: designed for vertical or horizontal mount.
• Specifically designed for use with ThermoFlo™ flexible ducting.
• Size: 8 inches (20 centimeters).

The Titan Controls™ Triton™ Standard Substrate Sensor is designed to accurately measure the EC (electrical conductivity), VWC (volumetric water content), and temperature of your substrate (growing media). Understanding these three metrics will allow you to optimize your irrigation strategy to realize your plants' full potential. The compact design allows this sensor to be easily installed in most applications.

• May be mounted on the exterior of a building.
• Enclosed motor housing for dust and lint.
• Suitable for air temperatures up to 140°F / 60°C.
• Energy efficient; speed controllable (optional solid state speed control).
• Heavy gauge, galvanized steel housing with baked epoxy finish; rugged construction for long life.
• Built-in backdraft damper.
• Exceptionally quiet and efficient BC centrifugal motorized impeller.
• External rotor motor design results in superior motor cooling and durability.
• Permanently lubricated ball bearing motor for maintenance-free operation.
• Automatic reset thermal overload protection.
• Fan and motor are precision balanced for quiet and vibration-free operation.
• Pre-wired capacitor.
• 120 V operation.
• 4 in (10 cm) 177 CFM external mount duct fan.

Can-Filter® has designed and built the Can-Lite™ for convenience and long life. 100% Australian Granulated carbon, aluminum top and bottom, integrated flange and 51% open perforation are features of the Can-Lite filter. The Can-Lite is available in 12 sizes with a CFM range of 89 - 3000. Can-Lite is manufactured in a dedicated carbon filter plant in North America. Each filter is shrink wrapped, boxed and labeled for ease of use.

Each Original Can-Filter® uses the most conceptually sound, granular carbon, packed-bed design to deliver the best performing carbon filter on the market. Even with the industry's thickest carbon bed, at 2.5 inches, the Can Original provides for some of the lowest pressure drops, even on smaller size filters. This hefty granular carbon bed effectively makes the Original filter the biggest sponge for VOC removal capable of holding massive amounts of contaminant leading to a lifespan that leaves other filters, frankly, in the dust. The Original Can-Filter are designed for the control of VOCs (paint fumes, hydrocarbons, etc...), odors and other gaseous contaminants. Built with the same proven packed bed design and granular virgin activated carbon we've used for 30 years, this line of time tested activated carbon air filters sets the standard for long life, consistent performance and low pressure drop. Rated at a conservative 0.1 sec contact time, the Original Can-Filter provide excellent value and confidence.

The flange is used to connect the Can-Filter® to the ducting or Can-Fan®; this is for airflow out of the ventilated area. These spun steel flanges come with a foam rubber seal and 6 hex drive self-tapping screws forming a perfect seal with Can-Filter products. Flanges range in size from 4 in to 20 in depending on your specific needs.

The flange is used to connect the Can-Filter® to the ducting or Can-Fan®; this is for airflow out of the ventilated area. These spun steel flanges come with a foam rubber seal and 6 hex drive self-tapping screws forming a perfect seal with Can-Filter products. Flanges range in size from 4 in to 20 in depending on your specific needs.

Very low air resistance, easily changed. MERV-5 mesh blocks pollen, dust and other particulate from entering filter. Available in sizes for all filters. A clean Can-Filter® Pre-Filter is an excellent way of extending the working life of your Can-Filter filter.

Can-Filters® has designed and built the Can-Lite™ for convenience and long life. 100% Australian granulated carbon, aluminum top and bottom, integrated flange and 51% open perforation are features of the Can-Lite filter. The Can-Lite is available in 7 sizes with a CFM range of 89 to 3000. Can-Lite is manufactured in a dedicated carbon filter plant in North America. Each filter is shrink wrapped, boxed and labeled for ease of use.

• Designed for ventilation applications including HVAC, dryer, grow rooms and tents.
• Four layer design makes it more durable and resistant to leaks, tears, and cuts.
• Steel-wire spiral structure is flexible and easy-to-install in hard to reach places.
• Constructed of Aluminum and thermoplastic, tube can be shortened for various applications.
• Ducting size: 8 inches (20 centimeters).
• Length: 25 feet (7.6 meters).
• Includes two stainless steel 8 inch duct clamps.